Structure Core 420
Triple Row Eurorack Enclosure
Order Now

 

Maximum HP. Maximum Power. Minimum Size.

Tons of space for modules and rock solid power housed in a minimalist hardwood case. The Structure Core 420 eurorack case offers a massive 420hp of space split into three rows paired with 60 power headers and 5 amps (5,000mA) of industry leading, clean, quiet power per rail. Hand built by our talented wood shop and finished with our signature black stain or raw unfinished hardwood ready for custom paint or stain.

For an even larger system, the Structure Core 420 fits perfectly on top of the angled Structure 420 using the optional Core Bracket Kit to create a gigantic studio centerpiece.

 

Structure Core 420 Power

  • 5 Amps of Clean, Filtered +12v Power

  • 5 Amps of Clean, Filtered -12v Power

  • 5 Amps of Clean, Filtered +5v Power

  • Case Wide 2 Channel Eurorack System Bus

  • 60 Keyed 16 Pin Eurorack Power Headers

  • External Power Switch with LED

  • Fused Power Protection

  • Universal IEC Power Connector

  • Discrete EMI filter per power rail (+12v, +5v, -12v)

  • Low Output Ripple & Noise

  • UL & CE Approved, RoHS Compliant

  • Over Load and Short Circuit Protection

  • Line Regulation (Full Load): ≤0.5%

  • Output Over Load Protection: 10%-150% Hiccup Mode with Auto-Recovery

 

Structure Core 420 Enclosure

  • Hardwood and Aluminum Construction

  • Three 140hp Rows

  • 420hp Total Space Available

  • Edge to Edge Bracket Free Rails Reduce Gaps Between Modules and the Side of the Case

  • 30 Smooth Sliding Square Nuts Per Rail Ensures Modules Always Fit Perfectly (Holds up to 90 modules)

  • Includes 180 Black (Size 4-40 1/4") Module Mounting Screws

  • Beautifully Hand-Stained or Unfinished Hardwood

 

Structure Core 420 Dimensions

  • External Depth: 3.5”

  • External Height: 16.5”

  • External Width: 29”

  • Minimum Internal Depth for Modules: 1 3/8” (35mm)

  • Maximum Internal Depth for Modules: 2 15/16” (74mm)

  • Empty Weight: 15 lbs. 4 oz.

 

Installing Modules

Installing modules into a Pittsburgh Modular Structure case is easy. Click on the installation guide below for a simple walkthrough of the 5 step process.

WARNING! ALWAYS TURN OFF AND UNPLUG THE CASE BEFORE ADDING OR REMOVING MODULES. Incorrectly installed modules can cause damage to the case and other modules. Double check the orientation of the power ribbon cable before plugging in and turning on the case. 

WARNING! ALWAYS FILL UNUSED PANEL SPACE WITH BLANK PANELS. Stray patch cables touching the power headers can cause damage to the case and modules. Always cover empty rack spaces with blank panels.

WARNING! Not all modules will fit snug against the left and right walls of the case. The design of the rail bracket requires 2mm of space on either side of the case 26mm below the panel. This allows us to offer a 120hp (610mm) of space from wall to wall without a visible bracket while still offering the strength and stability of a metal bracket. Depending on the design of the module, the 2mm on either side of the case, 26mm below the panel could effect the placement of deeper modules which utilize the full width of the panel for their PCB and prevent their placement up against the side of the case without leaving a small gap.

Voltage Switch Settings